Timer Settings

Configuration Name:

TELEMETRY ON BEACON ON GPS ON BLE ON START: SERVO PIN1,1000 //servo pin1 1000us SERVO PIN4,1000 //servo pin1 1000us PULL PIN2,1 //pull up pin2 WAIT PIN2,0 //wait until pin2 = 0 OUTPUT PIN3,1 //LED ON SERVO PIN1,1500 //servo pin1 1500us WAIT PIN2,1 //wait until pin2 = 1 (release the button) SERVO PIN1,2000 //motor max DELAY 5000 //delay 5000ms SERVO PIN1,1000 //motor stop DELAY 100 //delay 100ms SERVO PIN4,1500 //auto rudder SET COUNTDOWN_S,120 // set countdown for 120 seconds BEEP PIN5,2500 //beep pin5 @2500hz LOOP: IF COUNTDOWN,0 GOTO RDT: // if countdown=0 go to RDT ENDIF IF PIN6,1 // front hook sensor SERVO PIN1,1450 IF PIN2,1 // release hook sensor SERVO PIN1,1650 ENDIF ELSE SERVO PIN1,2050 ENDIF GOTO LOOP: SERVO PIN_4,2000 // DT action OUTPUT PIN_3,0 //LED OFF WAIT LANDING //Wait for landing GOTO FINDME: END: FUNC3: SERVO PIN1,1450 RETURN //RDT action RDT: //RDT line identifier SERVO PIN1,1000 DELAY 1000 //delay 1000ms SERVO PIN4,2000 GOTO FINDME: END: FINDME: LOWPOWER ON //Low power mode enabled. TELEMETRY OFF //Telemetry off BEACON ON GPS OFF BLE ON STROBE PIN3,2000 // strobe led ever 2 seconds END:

Default
F1A
F1E
F1Q

Hardware Info

Uptime: [UPTIME]

Battery Voltage: [VOLTAGE]

Core Temperature: [CORE_TEMP]°C

Hall Sensor : [HALL]

Compass : [COMPASS]

Altitude : [ALTITUDE]

CH1 Status: [CH1_READ]

CH2 Status: [CH2_READ]

CH3 Status: [CH3_READ]

CH4 Status: [CH4_READ]

CH5 Status: [CH5_READ]

CH6 Status: [CH6_READ]